The USB device has problems to start in windows XP mode from microsoft, even with USB2.0. I installed windows XP mode from microsoft, here the installation passes good (also windows XP version 2002 SP3), i will now test the hardware insterfaces and hopfully it will work as i should be. Even with that configuration the installation process was not successfully.
#Step 7 micro win pagina oficial install
Last attempt to let it run on vmware workstation, I did a clean install of windows XP SP3, without any network hardware selected at installation. In device manager you get an error that the device is stopped working, just plug in to a USB2 port or lower. Is it safe to install a version of vmware player next to vmware workstation?Īnyway i just want that the workstation version works fine.Īnyone who has an idea? Or know what the service s7oiehsx really does?Īnother solved issue that i experianced with USB 3, is that the USB communication adapter of Siemens will not work on a USB port 3. I've googled a lot and i hear from people that they have this configuration running well on a vmware player version. I already installed a new (for the second time) fresh windows XP from scratch on the vmware workstation, on top of that i installed also again the software.(only that software no other stuff) I run no software simultanious, just the vm in full screen. When i open windows calculator, i experiance also a slow user interface.Īll this i also tested with the service activated, with the same results.įirst of all, it is not my system that is too small for the job: An i7 processor with 16GB ram. In winCC flexible (another application) i experiance a slow response when scrolling.(what is also not normal) The problems that i experiance is that when i want to go online with my PLC system via network (bridged) the communication server crashes somtimes. The process "S7oiehsx.exe" uses 100% of the CPU time.Īfter ignoring this service, while installing this service always uses a big amount of CPU load (approx 25% when I have 4 cores and one cpu).Įven after reboot this service will go high (what i don't see on my standard XP configuration)Īfter a lot google visits, some say that this service is not necessery, so I stopped the service. When installing the industrial software of siemens STEP7 (intended to program PLC's with) the installation process isn't that normal.
This vm may use 3GB ram and has 4 cores and one processor. On this laptop i installed vmware workstation 8 and a virtual version of windows XP 32bit SP3 (also tested with SP2)
#Step 7 micro win pagina oficial 64 Bit
I have my new laptop, the vm host system that runs on windows 7 64 bit Here all the software is running well, no problems. I have a laptop (without vmware) with the configuration -> windows XP 32bit SP3